86
The Sapling Company, Inc.
1633 Republic Road
Huntingdon Valley, PA 19006
USA
P. (+1) 215.322.6063
F. (+1) 215.322.8498
www.sapling-inc.com
Connecting to the Clock
Connection Mode
- In connection mode, a properly configured Wi-Fi clock is accessible over the facility’s
network, and will appear on an IP Monitor located on the same subnet.
If the web interface is not accessed within four minutes of Connection Mode being activated, the clock will
automatically Cancel Current Mode and resume normal operations.
Direct Mode
- In Direct mode, a Wi-Fi clock acts as its own Wireless Access Point and can be accessed
directly from any Wi-Fi capable computer in range of it. In this mode, a clock will wait four minutes for the
user to access it before automatically deactivating its Wi-Fi transceiver.
While in Direct mode, the clock will temporarily change its IP address to 192.168.240.1. It will revert to
whichever IP address is listed on the Network Settings address page once Direct mode has been ended.
If the web interface is not accessed within four minutes of Direct Mode being activated, the clock will
automatically Cancel Current Mode and resume normal operations.
Cancel Current Mode
- When the WIFI SW button has been pressed three times, the Wi-Fi transceiver
will deactivate, and the user will no longer be able to access the clock through an Internet browser. The
transceiver will continue to obtain time data at the scheduled intervals, but the web interface will remain
inaccessible until Connection Mode or Direct mode is enabled again.
If the clock loses power for any reason, it will enter Connection Mode for one minute after power is
restored to the clock. If the web interface is not accessed within that minute, the clock will automatically
Cancel Current Mode and resume normal operations.
Access to the clock can be controlled through the WIFI SW
button. Pressing the button a given number of times will
perform the following actions.
1.
Start Wi-Fi transmitter in Connection Mode.
2.
Start Wi-Fi transmitter in Direct Mode
3.
Cancel Current Mode and resume normal operation.
The functions of each mode are as follows:
MECH SW
WIFI SW
