Samsung CY-SWR1100, User Manual

Page: 8 / 108

P
age
8 S
amSung
W
ireleSS
r
outer
u
Ser
’
S
m
anual
c
onnectIng to
a
nother
r
outer
If you are connecting the router to another router to use as a wireless access point and/or switch, you must do the following
before connecting the router to your network:
• Disable UPnP™
• Disable DHCP
• Change the LAN IP address to an available address on your network. The LAN ports on the router cannot accept a DHCP
address from your other router.
To connect to another router, please follow these steps:
1. Plug the power adapter into the router and connect the adapter to an outlet or power strip.
2. Turn on the router, and then connect one of your computers to the router’s LAN port using an Ethernet cable. Make sure
your IP address on the computer is 192.168.0.xxx (where xxx is between 2 and 254). If you need to change the settings,
write down your existing settings before making any changes. In most cases, your computer should be set to receive an
IP address automatically in which case you will not have to do anything to your computer.
3. Open a web browser and enter http://192.168.0.1 and press Enter. When the login window appears, set You name to
‘ admin ’ and leave the password box empty. Click Login to continue.
4. Click Advanced and then Click Advanced Network. Uncheck the Enable UPnP checkbox. Click Save Settings to continue.
5. Click Setup, and then Click Network Settings. Uncheck the Enable DHCP Server checkbox. Click Save Settings to con-
tinue.
6. Under Router Settings, enter an available IP address and the subnet mask of your network. Click Save Settings to save
your settings. Use this new IP address to access the configuration utility of the router in the future. Close the browser and
change your computer’s IP settings back to the original values as in Step 2.
7. Disconnect the Ethernet cable from the router and reconnect your computer to your network.
8. Connect an Ethernet cable to one of the LAN ports of the router and connect it to your other router. Do not plug anything
into the Internet (WAN) port of the router.
9. You can now use the other 3 LAN ports to connect other Ethernet devices and computers. To configure your wireless
network, open a web browser and enter the IP address you assigned to the router. Refer to the Configuration and Wireless
Security sections for more information on setting up your wireless network.
c
onnect to
c
able
/dSl/S
atellIte
m
odem
To access your network and the internet through the router, you must physically connect the router to your cable, DSL, or
satellite modem or to another router.
To connect the router to a cable/DSL/satellite modem, follow these steps
1. Place the router in an open and central location. Do not plug the power adapter into the router.
2. Unplug the modem’s power adapter. Shut down your computer.
3. Unplug the Ethernet cable (that connects your computer to your modem) from your computer and place it into the Internet
port on the router.
4. Plug an Ethernet cable into one of the four LAN ports on the router. Plug the other end into the Ethernet port on your
computer.
5. Plug in your modem. Wait for the modem to boot (about 30 seconds).
6. Plug the power adapter into the router and connect the adapter to an outlet or power strip.
7. Use the power switch to turn on the router. Wait about 30 seconds for the router to boot.
8. Turn on your computer.
9. For the information you need to continue the installation, go to “Required Network Information” on page 10.