Sam4POS 6600/4800II Operators Manual v2.9
Appendix
•
211
EFT Operation
EFT Operation Menu
Sam4POS supports credit card processing with Datacap integrated payment appliance and supports the
EMV integration protocol. (There will be no Non-EMV integration.) Credit Card
(EFT)
maintenance
operations can be performed at the Sam4POS terminal from the EFT Operation menu.
In the Pre-EMV environment Datacap stored some information in the Tran that allowed the registers to run
some reports, such as the local transaction report.
In the EMV environment Datacap no longer stores information in the Tran so there are no reports
available.
On the Sam4POS we are storing some information on the approvals at the register. This is required to be
able to perform
“By Record”
transactions.
Currently, if a Local Transaction Report is run we print the information from the approvals. However, this
data should only be used for troubleshooting and should not be relied upon as accurate.
For example, if you perform a sale for $1.00 and then perform a Void by Record Number of the same
transaction, you will have two transactions. The register is only printing the information from the
approvals.
Refer to the “Datacap Operation Definitions” on page 212 for details about these options.
1.
From the main
PROGRAM MODE
menu, select
DEVICE
, then choose
EFT OPERATION
,
from the device menu selections.
2.
The
EFT Operation
menu is displayed; select the
Datacap_Operation
.
3.
Refer to the appropriate Operation Definition menu below for information on each operation.
