Ross Synergy 2 SD, Installation Manual

Page: 166 / 414

7–10 • Basic Communications Setup Synergy Series Installation Guide (v18)
Peripheral Interface II Protocol Setup
Use the Peripheral Interface II Protocol Setup procedure to set up communications parameters with
a PIP-II device that can control up to 24 peripheral devices from a single remote port on the Synergy
switcher.
Ensure that the Peripheral Interface II Protocol option is installed. If not, please contact Ross Video
for details. Refer to the section “ Installed Options Menus ” on page 2–37 for instructions on
verifying the status of installed options.
Use the following procedure to configure a Synergy switcher communication port for a Peripheral
Interface II Protocol device:
1. Navigate to the Communications Menu 1-2 as follows:
• Press HOME B MORE B Setup B Installation B Communications .
2. Press Type to display the Type Menu .
Communications — Type Menu
3. Assign a com port to the PIP-II as follows:
• Use the Com Port knob to select the remote port on the Synergy switcher that is
connected to the PIP-II device.
• Use the Device knob to select PIP–II .
4. Press Select Device to display the Select Device Menu .
Communications — Select Device Menu
5. Select the PIP-II protocol for the PIP-II communications port as follows:
• Use the Com Port knob to select the communications port you want to assign a
PIP-II device to.
• Use the Device knob to select PIP–II .