Ross Synergy 2 SD, Installation Manual

Page: 213 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–37
Peripheral Interface II Custom Controls
A custom control button can be programmed to send messages to devices using the Peripheral
Interface II Protocol.
Use the following procedure to create a custom control that will send commands to devices using the
PIP-II protocol:
1. Navigate to the Custom Controls Menu as follows:
• Press
HOME B Custom Controls
.
Custom Controls Menu
2. Select the custom control button you want to record to as follows:
• Use the Bank knob to select the custom control bank you want to record the custom
control to.
• Use the
Button
knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) in the list have
already been programmed.
3. Navigate to the Insert PIP-II Menu as follows:
• Press
Start Recording B Insert Special B PIP-II
.
Insert PIP-II Menu
Note Ensure that the Peripheral Interface II Protocol (PIP-II) option is
installed and that the PIP-II device you want to control is properly
connected and configured with the Synergy switcher. Refer to the
section “
Peripheral Interface II Protocol Setup ” on page 7–10 for
more information on setting up a PIP-II device.
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.