Ross Synergy 2 SD, Installation Manual

Page: 273 / 414

Synergy Series Installation Guide (v18) Additional Installation Setups • 9–43
Switcher Calibration
The Calibration Menu allows you calibrate all analog controls on the switcher panel, including the
faders, the XYZ positioner, and all knobs (excluding those to the right of the display). The
Calibration Menu includes the following information:
• The Main Area provides a visual display of all analog controls, including the faders,
positioner, and all the knobs.
• The Label Area provides only one function, Accept .
Calibrating the Analog Controls of the Synergy Switcher
Use the following procedure to calibrate the switcher’s analog controls:
1. Navigate to the Calibration Menu as follows:
• Press
HOME B MORE B Setup B Installation B MORE B Calibration
.
Calibration Menu
2. To calibrate the faders:
• Move each fader to its full upper and lower limit.
• Repeat this procedure two or three times for each fader .
As you move the faders, you will see a series of numbers appear in the Main Area ,
under the FADERS heading. The numbers for each fader may not match — this is
normal.
3. To calibrate the positioner, move each axis as follows:
• Calibrate the X-Axis by moving the joystick fully left and right. Repeat this
procedure two or three times.
Caution
Use this mode with caution. Perform the calibration only when you
suspect that there has been “drift” in the knobs or the joystick, or that
there is a “limit” problem with a fader.
Important
You must calibrate all analog controls on your switcher. Failure to do
so will map a false limit into switcher memory [for the control(s) that
you did not calibrate], thus preventing proper switcher operation.
Note The screen shot shown above is for a Synergy 4. The number of
Faders (as shown in the FADERS column) differs on the Calibration
Menu for the Synergy 2 and 3 switchers.