Ross Synergy 2 SD, Installation Manual

Page: 237 / 414

Synergy Series Installation Guide (v18) Additional Installation Setups • 9–7
In Appendix D, refer to the “ Bus Mode Setup ” section for detailed instructions on
Bus Follow
mode and the associated
Bus Assign
softkey on the Bus Follow
Menu .
6. Use the
Xpt
knob to select the method for assigning the selected Aux Bus. You can
select between the following:
•
MLE Xpts
— Use this option to assign your Aux Bus crosspoints using MLE
crosspoints.
•
Definable
— Use this option to assign your BNC inputs individually to the Aux
Bus crosspoints. Ensure that you have assigned the Aux Bus to Regular Mode in
step 5.
This concludes the procedure to assign MLE crosspoints to the local Aux Panel crosspoints. Refer to
the section “
Assigning BNCs to Aux Panel Crosspoints ” on page 9–7 for information.
Assigning BNCs to Aux Panel Crosspoints
All Definable Aux Buses, as assigned in the Aux Bus Setup Menu , have the same crosspoint
mapping. As a result, when you change a crosspoint assignment on one definable Aux Bus, the new
assignment applies to
all definable Aux Buses. The Aux Bus Local Panel Setup Menu allows you to
set specific switching parameters (or “rights”) for each of the 12 Aux Buses that are accessible from
the control panel (in the
Aux Bus Assign Group ). Each bus can be set up individually.
Use the following procedure to assign a crosspoint on the local Aux Panel to a BNC:
1. As required, refer to your Auxiliary Output Worksheet . Refer to the section
“ Connecting and Verifying Outputs ” on page 4–15 to verify the destinations and
functions of all Aux Bus outputs.
2. Navigate to the Aux Bus Setup Menu 1-2 as follows:
• Press
HOME B MORE B Setup B Installation B Aux Bus
.
3. Press
Local Panel
to display the Aux Bus Local Panel Setup Menu .
Aux Bus – Local Panel Setup Menu
4. Configure an Aux Bus to
Definable
as follows:
• Use the
Aux Bus
knob to select the Aux Bus that you want to set as Definable. As
you scroll, each selected button lights in the Aux Bus Assign Group .
Note In Bus Follow mode, the user is “locked out” of the designated Aux
Bus and can not make selections on the Aux Bus panel itself.
Operating
Tip
You can also press a button in the Aux Bus Assign Group to select the
Aux Bus that you want to configure.