Ross Synergy 2 SD, Installation Manual

Page: 86 / 414

2–42 • Installation Synergy Series Installation Guide (v18)
• The option(s) that you wish to install. Technical Support keeps an up-to-date record
of each switcher’s configuration and option status.
6. You will be given a numeric code for each option. Enter the code on the keypad in the
switcher’s Global Memory Area .
7. Press
ENTER
on the keypad or press
Finished
on the Serial Number Menu . Once
entered, the menu indicates “ Installed ,” and the system displays the Software Options
Menu to confirm.
8. Repeat steps 5 and 6 for each option.
This completes the procedure to activate your software options.
Storing Option Codes
The Installed Options Menu 2-2 allows you to store and recall your option codes to a storage device,
such as a floppy disk or USB key, for purposes of safe storage.
Use the following procedure to store option codes:
1. Navigate to the Installed Options Menu 2-2 as follows:
• Press HOME B MORE B Setup B Installed Options B Software
Options B . MORE .
Installed Options Menu 2-2
2. Insert a storage device into the Synergy switcher as follows:
• Insert a pre-formatted 1.4 MB high-density floppy disk into the floppy drive of the
switcher.
OR
• If you have the USB Removable Media Drive option installed, insert a USB key
into the USB port of the Synergy switcher. You must wait 5 seconds after inserting
the USB key into the USB port before you can store option codes to it.
3. Press Store Codes to Disk to store all of your option codes.
4. Eject the storage device from the switcher.
Operating
Tip
Make a written note of your serial number and each option code, and
store them in a safe place for future reference.
Caution
Do NOT remove the floppy disk or USB key from the switcher before
the LED on the floppy drive or USB port goes out. Doing so may
destroy the data on your floppy disk or USB key, as well as the data on
the next one you insert into the switcher.