Ross Synergy 2 SD, Installation Manual

Page: 199 / 414

Synergy Series Installation Guide (v18) Custom Control Basics • 8–23
Custom Controls Menu
2. Select the custom control button you want to record to as follows:
• Use the
Bank
knob to select the custom control bank you want to record the custom
control to.
• Use the Button knob to select the custom control button that you want to record a
custom control macro to. You can also press the desired button directly on the
control panel. Remember that buttons marked with an asterisk (*) in the list have
already been programmed.
3. Navigate to the Special Menu as follows:
• Press
Start Recording B Insert Special B Special
.
Insert Special — Special Menu
4. Assign the trigger GPI to a GPI output as follows:
• Use the top knob to select
Trigger GPI
.
• Use the GPI Output knob to select the GPI output port you want to trigger.
5. Press
Insert
to insert the selected command into the custom control and display the
Insert Special Menu 1-2 .
6. Insert additional commands if needed. When you have finished inserting commands,
proceed to the next step to complete the procedure.
7. Press
UP ONE
to display the Recording Menu .
Operating
Tip
As a recommendation, keep special functions grouped together on
your
physical custom control buttons.
Note The names that appear in the GPI Output list are programmed on the
GPI Output Setup Menu . Refer to the section “ Standard GPI
Setup ” on page 11–26 for details.