Ross Synergy 2 SD, Installation Manual

Page: 82 / 414

2–38 • Installation Synergy Series Installation Guide (v18)
Notes on Using the Software Options Menu
Please note:
• The menu is provided for information only — no action can be taken.
• If a serial number appears at the top of the menu, please verify that the list reflects the
exact options that you have purchased. If not, please contact
Ross Video Technical
Support for further information.
• If the label “ Unknown ” appears, the frame is turned off. Please turn on the frame so that
the serial number can be recognized.
• If the label “ 000000 ” appears, a serial number is required. Your options will temporarily
be activated but a valid serial number must be installed permanently — so that you do
not lose switcher functionality. Refer to the section “ Installing Serial Numbers ” on
page 2–40 for instructions.
• Serial numbers are unique, and pertain to your switcher only . The serial numbers cannot
be exchanged, or entered on another switcher.
Panel Boards Menu
The Main Area of the Panel Boards Menu provides three columns of information that pertain to the
boards installed in the panel:
• Column 1 ( Board ) lists each circuit board by part number and name.
• Column 2 ( Rev ) lists the board’s hardware revision number.
• Column 3 ( FPGA Rev ) lists the board’s software revision number.
Use the following procedure to view the control panel boards you have installed on your Synergy
Series SD switcher:
1. Navigate to the Installed Options Menu 1-2 as follows:
• Press HOME B MORE B Setup B Installed Options .
2. Press Panel Boards to display the Panel Boards Menu .
Installed Options Menu — Panel Boards
3. Use the middle knob to scroll the list. Note that the menu is provided for information
only — no action can be taken.
This completes the procedure to view the control panel boards you have installed on your Synergy
Series SD Switcher.