Ross Synergy 2 SD, Installation Manual

Page: 268 / 414

9–38 • Additional Installation Setups Synergy Series Installation Guide (v18)
Aux Bus Remote Panels Setup Menu
2. Go to the first assignable or dedicated Aux panel that you want to program.
3. Ensure that the panel is in “programming” mode (with the on-air LED flashing).
4. Press CLEAN FEED to switch the panel from “assignment” programming mode to
“GPI” programming mode. The CLEAN FEED button flashes to indicate that GPI
programming mode is active.
With the GPI programming mode in effect, the first eight crosspoints on each panel
allow you to set the selected panel’s group and offset, as indicated below.
Remote Aux Panel GPI Group and Offset Programming Buttons
5. Press the crosspoint for the group and offset that you want to assign to this Aux Panel.
The button lights to indicate your selection. Only one switch can be lit at a time.
6. To test your GPIs locally for valid contact closures, press each joystick button on the
CCUs that are connected to this panel.
As you press the CCU joystick buttons, the LEDs in the second group of eight
crosspoints on the panel will indicate when each GPI has been shorted to ground, as
shown below.
Remote Aux Panel Button GPI Contact Closure Status Buttons
Important
GPI status buttons are numbered from left to right, starting at GPI 8
and counting down to GPI 1 . These correspond to the 8 available ports
on each panel, and also correspond to the arrangement of GPI icons on
the
Remote Panels Menu .
BLCK
MLE
1
MLE
2
MLE
3
CLEAN
FEED
PGM
ASSIGN
+4
ASSIGN
+8
ASSIGN
1
ASSIGN
2
ASSIGN
3
ASSIGN
4
SHIFT PV
Group 1
Offset 0
Group 2
Offset 1
Group 3
Offset 2
Group 4
Offset 3
Group 5
Offset 4
Group 6
Offset 5
Group 7
Offset 6
Group 8
Offset 7
BLCK
MLE
1
MLE
2
MLE
3
CLEAN
FEED
PGM
ASSIGN
+4
ASSIGN
+8
ASSIGN
1
ASSIGN
2
ASSIGN
3
ASSIGN
4
SHIFT PV
GPI 8
GPI 7
GPI 6
GPI 5
GPI 4
GPI 3
GPI 2
GPI 1