Ross Synergy 2 SD, Installation Manual

Page: 320 / 414

11–4 • Still Stores Synergy Series Installation Guide (v18)
Still Store Interface Cable Pinouts
Use the information in this section to connect the Interface Cable from the Synergy switcher to the
Still Store.
Chyron Aprisa 100 Still Store Cabling
The Synergy control panel connects to an Aprisa 100 Still Store via the remote ports on the Synergy
control panel, and the RS-422 port or the RS-232 port on the rear of the Aprisa 100 Still Store.
Cable connections in the following table refer only to those between the Synergy control panel and the
Aprisa 100 Still Store. Other cable connections present on the Aprisa 100 chassis can be found in the
Chyron Aprisa 100 documentation.
Synergy-to-Chyron Aprisa 100 RS-422 Wiring Chart
Synergy Control Panel Chyron Aprisa 100
Remote Port Signal RS-422 Port Signal
1 Chassis
2 RxA (Rx-)
→
9 TxA (Tx-)
3 TxB (Tx+)
→
6 RxB (Rx+)
4 n/c
5 Ground
6 Ground
7 RxB (Rx+)
→
8 TxB (Tx+)
8 TxA (Tx-)
→
7 RxA (Rx-)
9 Chassis
Important For RS-232 cables, only pins 2 , 3 , and 5 should be connected. All
other pins must be disconnected.
Synergy-to-Chyron Aprisa 100 RS-232 Wiring Chart
Synergy Control Panel Chyron Aprisa 100
Remote Port Signal RS-232 Port Signal
1 Chassis
2 Tx
→
2 Rx
3 Rx
→
3 Tx
4 n/c
5 Ground
→
5 Ground
6 n/c
7 n/c
8 n/c
9 Chassis