Ross Synergy 2 SD, Installation Manual

Page: 81 / 414

Synergy Series Installation Guide (v18) Installation • 2–37
Installed Options Menus
Several important menus are available that allow you to verify all of the installed options in your
Synergy switcher — with serial numbers as well as software option codes. The menus also display the
revision levels of all system boards, and allow you to install software options. In its initial state, the
Main Area and Scroll Area of the Installed Options Menu are both blank. The Label Area provides
an array of options which are discussed in the following sections:
• Menu Access
• Software Options Menu
• Panel Boards Menu
• Frame Boards Menu
• Option Boards Menu
• Installing Serial Numbers
• Installing Software Options
• Storing and Recalling Option Codes
Software Options Menu
The main area of the Software Options Menu lists your Synergy frame’s serial number at the top.
This number is present at the top of all options menus. The main area also provides two columns of
information:
• Column 1 lists the available software options.
• Column 2 indicates whether or not the option is installed.
Use the following procedure to view the software options you have installed on your Synergy
switcher:
1. Navigate to the Installed Options Menu 1-2 as follows:
• Press HOME
B
MORE
B
Setup
B
Installed Options .
2. Press
Software Options
to display the Software Options Menu .
Installed Options — Software Options Menu
Important
Serial numbers allow Ross Video to properly track which options have
been purchased by each customer. Switchers shipped in August 1999
and later have serial numbers installed (in flash memory) at the factory.
Switchers shipped before August 1999 do not have serial numbers
installed. Refer to the section “
Installing Serial Numbers ” on
page 2–40 for instructions.