Rosemount P330, Installation And Operation Manual, Page: 78 / 92

Rosemount Model P330 Pressure Validator
8-4
Manual Logging Setup and
Procedure To set up and run a manual Datalog test, refer to Figure 8-5 and
proceed as follows:
FIGURE 8-5. Setting Up a Manual
Datalog File.
1. Press the
STORE
key.
2. Press
F1
to begin entering the filename.
a. Use ¶ and Ä to scroll through digits.
b. Use
©
to move to next digit or
§
to move back.
c. When correct name is displayed, press
ENTER
.
d. Use Ä to move to the next parameter.
e. Follow steps 1a–1d to enter data and move to next parameter.
3. Set the
TRIGGER
parameter to
KEYPRESS
using © .
4. When all parameters have been entered, press F2 to start logging.
The task screen is redisplayed.
5. Press F2 to turn on 24 V power, if necessary.
6. Press
F1
to run the test. Use a combination of
STORE
and
F1
LOG
NOW
to log data points as shown in Figure 8-6:
FIGURE 8-6. Manually Logging Data
Points.
7. Press F2 to stop the test.
P
330
_4
0A
LOG
NOW
STOP
LOGGING
STORE
P
3
30
_4
1
A