Manual
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Communication with the PLC
B0059001 / Rev. 2.3
58
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
5.2.4 Bus address
The bus address of the SND40 (Slave address) is assigned in the system configuration with the
parameters
"field bus address"
and
"baud rate"
.
Depending on the type of fieldbus, the valid range of values is different.
Note:
The range of values is not checked by the SND40 during the input.
Example with Fieldbus interface in the Profibus DP version:
•
Fieldbus address
: 1
•
(here the address 1 is entered)
Addressing the ProfiNet module
The MAC-ID is hardware preset and cannot be set / changed. It will be displayed in the hardware
info of the SND40.
At the machine control the SND40 can be identified by this MAC-ID.
Settings of bus address and baud rate (depending on fieldbus type):
Fig. 33: SND40 Fieldbus address
