Manual
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
B0059001 / Rev. 2.3
Maintenance
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
133
10.5.3.1 Function „Save system and program files”
This function saves all system and program configuration files from the SND40 program
directory to a freely definable directory on a connected USB stick.
After selecting the function, a dialog
window reminds that the USB stick
MUST be connected to proceed.
Confirm by pressing “
Yes
”.
Note
It is also possible to connect the USB stick after starting the function,
but then it is necessary to wait a few seconds, so that the operating
system can recognize the USB stick properly.
After confirming the message, the program checks if the USB stick is present. If the result is
negative, you will receive a corresponding error message and the function will be aborted.
If the USB stick is identified as “
Hard Disk
”,
the selection must be done where the
backup directory should be created.
This selection defines the so-called backup
root directory, in which the actual backup
directory with the saved files is saved.
For this, the program displays a dialog
window to select the directory; there, the
main directory of the USB stick is already
selected.
