Roland DXY-1100, Command Reference Manual

Page: 35 / 156

y
X
Drawing start position
Fig. T-1
Parameter d specifies the intervals between hatching lines and must be in the range
-3 2 7 6 8 .0 0 0 0 to + 32767.4999.
When only a rectangle is drawn (ie. n = 2), this parameter d cannot be omitted as a dummy.
Fig. T -2
Parameter t specifies the hatching angle.
The hatching angle is specified as 0°, 4 5 °, 90°, or 135° with the parameter t values 1, 2, 3, or
4 . Decimal fractions are rounded up or down to the nearest integer. If a value other than one of
these four is specified, the T command is ignored. When only a rectangle is drawn (ie:n = 2), a
value of 1 to 4 must still be entered as a dummy.
t= 1 (0°) t = 2 (45°)
Fig. T-3
2-25