Roland Camm-1 Pro GX-300, User Manual

Page: 25 / 84

23
SELECT SHEET
*ROLL
W:1195mm
L:------ [0mm]
9
10
The SETUP LED lights up (setup state), and the
horizontal width of the material is detected and shown
on the display. Setup is now complete.
When securing material, be sure to use the left and right pinch rollers, and
position them properly above the grit rollers. If the pinch rollers are improp-
erly positioned, the width of material may not be detected accurately, or the
error shown at right may occur. If this happens, either unload the material
(see “3-6 When Cutting Is Completed”), or press the [ENTER] key to clear
the error, then reposition the pinch rollers correctly to load the material
precisely.
When using roll material, before you perform cutting you need to pull out the required length of material from the roll.
For more information, refer to “Material Test Feed” in “3-5 Starting Cutting”.
3-2 Installing a Blade
Do not touch the tip of the blade
with your fingers.
Doing so may result in injury, and the
cutting performance of the blade will be
impaired.
Be sure to support the tool mounting screw from below when installing the blade holder. If installed without
supporting the screw in this way, the blade tip may strike the blade protector, damaging the blade or blade
protector and impairing cutting quality.
NOTICE
1
Insert the pin into the blade holder.
2
Insert the blade.
POWER LED lights up
8
Switch on the power.
BAD POSITION
Pin
Blade holder
At [SELECT SHEET], use the [ ] and [ ] keys
to select [ROLL], then press the [ENTER] key.
For more information about selecting material, see “4-
2 Details of the Origin-point Location and Cutting
Area.”
Blade