Roland Camm-1 Pro GX-300, User Manual

Page: 28 / 84

26
• Some parts of the material remain uncut. • Cutting takes a long time.
Blade force
• The material peels during the cutting.
• The blade requires frequency replacement.
• Cutting extends through the base paper, and normal
advancing of the material becomes impossible.
• The blade protector is damaged.
Too large
Too small
Cutting-speed
• Uncut areas remain in places.
• The cut depth differs according to the location
(nonuniform cutting depth).
• The material peels.
• The cut shape is distorted.
Too fast
Too slow
W:600mm
L:----- [0mm]
Adjusting the Cutting Speed
Examine the results of the cutting test and adjust the cutting speed accordingly.
1
Press the [SPEED] key to display the screen in the
figure.
2
Use the [ ] and [ ] keys to adjust the value, then
press the [ENTER] key to enable the setting.
Incorrect cutting conditions may cause symptoms such as those described below.
3-4 Setting the Origin Point
With this machine, you can set the location where cutting starts (the origin point) at any position.
If the default origin point just after setup is acceptable, there is no need for you to explicitly set the origin point.
Setting the origin point at the point you want on the material lets you start cutting at any location you like, which can help reduce
wasted material.
1
Press the [ ], [ ], [ ] and [ ] keys to move
the blade to the location where you want to set the
origin point.
2
Hold down the [ORIGIN] key for 0.5 seconds or
longer.
SPEED 20cm/s
*20cm/s
Setting range:
1 to 85 cm/s (settable in
increments of 1 cm/s)
Cutting-speed adjustment