Roland Camm-1 Pro GX-300, User Manual

Page: 38 / 84

36
X
Y
Origin point
X
Y
Origin point
[0deg] [90deg]
Coordinate Rotation Settings
This rotates the cutting coordinates by 90 degrees. The default setting is at [0deg], and the origin point is set at the lower left of the
material. Setting this to [90deg] set the origin point at the lower right of the material and rotates the text (or graphics) by 90 degrees.
* Note that the coordinate axes change when rotated. Make the settings to match the program you're using.
When this is set to [90deg] on the operation panel, then the CAMM-1 driver's [Rotate] setting must be set to [Rotate off].
When rotated 90 degrees, the X axis, Y axis, and origin point change as follows.
1
Press the [MENU] key several times until the screen
shown in the figure appears.
2
Press the [ ] key.
Press the [ ] key.
3
Press the [ ] key several times.
4
Press the [ ] key.
Use the [ ] and [ ] keys to select [90deg].
5
Press the [ENTER] key to enable the setting.
Press the [MENU] key to back to the screen shown in
the figure.
UNSETUP
FORCE 50gf
20cm/s
50gf 0.250mm A
ROTATE 0deg A
ROTATE 0deg A
*90deg A