Roland Camm-1 Pro GX-300, User Manual

Page: 24 / 84

22
Material
Guide-line marks
Pinch roller (right)
Lower the pinch roller inside the
material.
Rear View
Sheet loading lever
Material
5
Pull out material toward the front, position it in place so that it is lined up straight with the guide lines, then move the left and
right pinch rollers to position them above the grit rollers.
Position the middle pinch roller at the center between the left and right pinch rollers. If a grit mark is present between the left
and right pinch rollers, position the middle pinch roller above the corresponding grit roller.
If the pinch rollers do not move smoothly, try moving them by grasping near the base of the sheet loading lever at the back of
the unit. Load the material so that it is straight. If the material is crooked, straight material feed cannot be performed.
* The GX-300 does not have a middle pinch roller.
Screws
Brake
Roll material
Stopper
6
Raise the sheet loading levers.
The pinch rollers are lowered and the material is
secured in place.
When using a material which is narrower than 762 mm
(30 in.), do not lower the middle pinch roller.
7
Position the stoppers so that they lightly touch the
edges of the roll and secure in place by tightening the
screws so that the roll material does not move from
side to side during material feed.