Roland Camm-1 Pro GX-300, User Manual

Page: 30 / 84

28
CONTINUE PAUSE
STOP ENTER
To Sever the Material
With this machine, it is possible to cut off the material after performing cutting.
Holding down the [SHEET CUT] key for 0.5 seconds or longer severs the material.
Press the [PAUSE] key.
Cutting is paused and the screen shown in the figure appears
on the display.
[To Resume Cutting]
Press the [PAUSE] key.
Cutting is resumed.
[To Terminate Cutting]
First of all, stop the flow of data being sent by the computer.
Then hold down the [ENTER] key for 0.5 seconds or longer.
Cutting stops and the screen shown in the figure appears on
the display.
Pausing Cutting Operations
If you want to pause cutting, follow the procedure described below.
20cm/s
50gf 0.250mm A
Downloading Cutting Data
Cutting starts when the machine receives cutting data sent from the computer.
If the material becomes dislodged or there is a problem in operation, then immediately press the [PAUSE] key
or turn off the power switch on the right side of the machine.
NOTICE
The CAMM-1 driver is necessary to perform cutting with this machine using data created by another program.
The CAMM-1 driver is found on the included CD-ROM. For information on how to install it, take a look at the included Setup
Guide.