Brief Introduction to Remote Control
R&S
®
FSVA/FSV
163
Quick Start Guide 1321.3066.02 ─ 05
CALL InstrWrite(analyzer,"DISP:TRAC1:MODE WRIT")
'Set trace to Clr/Write
CALL InstrWrite(analyzer,"INIT;*WAI") 'Start sweep
END SUB
REM ************************************************************************
7.2.4.3
Setting the Data Record for Startup Recall
In the following example, the first step is to change the R&S
FSVA/FSV to the
default state. In the next step, the
TEST1
data record stored under
C:\R_S\Instr\user
is selected for the startup recall function, i.e. the data
record is then set after each
*RST
, presetting and each time the instrument is
started. For demonstration purposes, the command
*RST
is carried out again.
REM ************************************************************************
Public Sub StartupRecallSettings()
'--------- Resetting the R&S FSV ------------------------------------------
CALL InstrWrite(analyzer,"*RST")
'--------- Default setting of the status register --------------------------
CALL SetupStatusReg 'Configure status register
'--------- Selecting the startup recall data record ------------------------
CALL InstrWrite(analyzer,"MMEM:LOAD:AUTO 1,'C:\R_S\Instr\user\TEST1'")
'--------- Activating the startup recall data record -----------------------
CALL InstrWrite(analyzer,"*RST")
END SUB
REM ************************************************************************
7.2.5
Configuring and Starting a Printout
The following example shows how to configure the output format and output
device for printing out a measurement screen. The procedure is as follows:
1. Set the measurement you want for the printout.
2. Check which output devices are available on the instrument.
3. Select an output device.
4. Select the output interface.
5. Configure the output format.
6. Start the printout with synchronization to completion.
Detailed Programming Examples
Summary of Contents for R&S FSV
Page 25: ......
