Palletizing Solution - Instruction Manual
3.2. Required Tools and Equipment
The following tools are required to install the Palletizing solution.
Included:
l
12.7 mm (1/2 in) concrete drill bit (for use with hammer drill)
l
19 mm (3/4 in) socket, 10 mm (3/8 in) drive size
l
17 mm socket, 10 mm (3/8 in) drive size
l
2 mm hex key
l
3 mm hex key
l
4 mm hex key
l
5 mm hex key
l
6 mm hex key
l
10 mm hex key
Not included:
l
Lifting equipment (min. capacity of 200 kg) such as a gantry crane, overhead crane, jib crane, chain block or forklift with a proper
lifting hook
l
Power screwdriver
l
#2 Phillips bit
l
2.5 mm slotted screwdriver
l
Utility knife
l
Ratcheting socket wrench with 10 mm (3/8 in) drive or adapter
l
Torque wrench with 10 mm (3/8 in) drive or adapter, minimum torque range of 20 - 50 Nm (14.8 - 36.9 ft-lb)
Additionally, if you decide to install the type of anchors provided by Robotiq, you will need the following:
l
Hammer drill
l
Hammer
24
Summary of Contents for PALLETIZING SOLUTION AX Series
