Fig. 2-1: Safety Logical Schema
Warning
In the event of a collision or after an emergency stop, an inspection of the solution must be performed before resuming the
use of the machine. Special attention must be given to the carriage assembly, the linear axis, the cable management
system, and the gripper components. Please contact
if any sign of damage is detected.
2.3.2. Linear Axis Stop Category 0 and 1
When a stop is required, the robot and the linear axis start the process at the same time, even if they are independent, so the
stopping time can differ.
l
For robot information, please refer to the Universal Robots documentation.
l
For the linear axis:
o
Maximal stopping time for Category 1: 500 ms;
o
Maximal stopping time for Category 0: 100 ms*;
o
Travelled distance when there is a stopping time: 33 mm (1-5/16 in)*
*For cases where the robot is immobile, with a payload of 8 kg and the initial speed of the linear axis is 500 mm/s, which is the
maximum allowed speed.
20
Summary of Contents for PALLETIZING SOLUTION AX Series
