Rittal BC 1007 HS, Manual

Page: 20 / 92

20
3.4.6 Adjusting the Oil Mist Angle
An optional adjustable spray nozzle mount is available. If equipped, this adjustable mount
allows the operator the flexibility to adjust the angle of the oil mist. This feature is especially
necessary when using the milling tool extension (Milling surfaces that require a negative
offset, the mist may be adjusted to match the negative offset).
To adjust the mist angle;

Drill, tap or mill a machined surface.

Visually check the machined surface and look for oil residue.
o
If oil residue could not be
seen, turn up the mist
volume, see Section 3.4.3.

When the angle of the mist is
correct;
o
¼ of the residue should be
above the cut when not
using the pressure plate.
o
⅓ of the residue should be
above the cut when using
the pressure plate.

Adjust the spray angle if needed
and repeat the cut. Be sure that
the oil mist is delivered properly
for both pressure plate positions
(On/Off).

Once the angle is correct, tighten
all the thumb screws on the
adjustable spray mount.