Rittal BC 1007 HS, Manual

Page: 11 / 92

11

Y-Axis Locations;
Note: These locations are difficult to access and only the
recommended grease gun will fit between the spindle
mounting plate and the linear way.
o
Two above the spindle mount plate and two
below the spindle mount plate. The lower
grease fittings are not shown in the photo.
o
Moving the Y-Axis may be required to gain
access to these grease locations.

Z-Axis Locations;
Note: Removal of the spindle covers will be required to
grease the two fittings furthest from the spindle chuck.
o
Two bearings will be located on the
linear guide rail near the spindle
chuck and two on the opposite end of
the spindle, near the spindle fan.

Motorized Table for enclosure clamping;
o
Two bearings will be located forward
of the motorized table and two behind the motorized table.