74
3.20.1
Saving Parameters to Device and Hard Disk
When parameters have been modified, the new parameters will need to be permanently
saved to the drives and to the hard disk. If the parameters are not saved, the machine will
revert to the old values when the machine is restarted.
Note: Be sure the parameters are correct before saving permanently, this cannot be undone.
To properly save the machine parameters;
1.
Navigate to [4] System, [4] Darc-Service
2.
Right-click Parameter Sets and select Connect from the list of options.
3.
Right-click “Parameter Sets”.
4.
Select “Save all Parameters Permanently” or, if in German, “Alle Geräte speichern
dauerhaft”.
5.
When asked to save to hard disk, select “Yes”.
Note: Be sure to “Calibrate the Axis Base Offset” in Section 3.21 before pickup up a tool from the
magazine.
Summary of Contents for BC 1007 HS
