Ricoh InfoPrint 1570, User Manual, Page: 55 / 148

Printing from a USB flash memory device
55
Printing
We recommend using the following tested and approved USB flash memory devices in the 256 MB, 512 MB, and 1 GB
sizes:
• Lexar JumpDrive 2.0 Pro
• SanDisk Cruzer Mini
Other USB flash memory devices must:
• Be compatible with the USB 2.0 standard.
• Support the Full-Speed standard as well.
Devices only supporting USB low speed capabilities are not supported.
• Use the FAT file system.
Devices formatted with NTFS or any other file system s are not supported.
To print from a USB flash memory device:
1
Make sure the MFP is on and
Ready
or
Busy
appears.
2
Insert a USB flash memory device into the USB Direct interface.
Note: If you insert the memory device when the MFP requires attention such as when a paper jam has
occurred, the MFP ignores the memory device.
3
Touch the arrow next to the document you want to print.
A screen asking the number of copies to be printed will appear.
4
To print only one copy, touch Print , or touch + to enter the number of copies.
Note: Do not remove the USB flash memory device from the USB Direct interface until the document has
finished printing.
The document will begin printing.
Note: If you insert the memory device when the MFP is busy printing other jobs, the message
Printer
Busy
appears. Select Continue , and your job prints after the other jobs finish.
If you leave the device in the MFP after exiting the USB drive menu, you can still print PDFs on the device as held jobs. See
Printing confidential and held jobs .