Rackable Systems OmniStor 4700S Series, User Manual

Page: 55 / 108

43
Chapter 4
Managing and Monitoring
In this chapter you will find information about using the enclosure’s onboard monitoring
systems and the procedures to update the controller firmware.
The interface to the enclosure’s monitoring system and firmware programs is provided
through a VT-100 terminal (or emulation) connected to the RAID Controller Service port.
If you are using StorView, refer to the StorView Storage Management software guide for
details on the GUI-based software monitoring.
You should monitor your storage system regularly to ensure that the disk drives, controller,
arrays, and enclosure components are working properly. Use the Status Indicator LEDs,
power supply LEDs, Drive LEDs, and the software to monitor the enclosure components,
fan status, disk drive status, controller status, and arrays.
Enclosure Component Monitoring
This section provides an explanation of the notifications provided by the front bezel LEDs
and an explanation of the One-Touch Annunciation configuration display system.
As part of the monitoring system, an audible alarm works in conjunction with the front
bezel LEDs. The alarm will sound for any fault that occurs with an enclosure component.
To silence the alarm, simply press the Alarm Reset button.
During boot, all LEDs on the front bezel except the Power On LED will turn amber until the
controller has completed its power on self test. When the controller comes ready, all the
LEDs will change to green indicating the system is ready.