Chapter 3 - Setup and Installation
Cabling the DC Power Supplies
32
Attaching the Power Cord Bales
NOTE:
For DC Power Supply Systems refer to Cabling the DC Power Supplies
below.
3
Repeat the above steps for each additional storage system enclosure you will be
installing.
This completes the physical hardware installation.
Cabling the DC Power Supplies
NOTE:
Refer to “DC Power Supply Connector Pinout” on page 88 for wiring and
connector details.
If you are using the DC Power Supply system, refer to the following procedures to properly
connect the cables.
1
Plug the connector into the power supply, it is keyed to install only one way.
2
Connect the two Red pair wires to the DC Feed +48VDC connection.
3
Connect the two Green/Yellow pair wires to the DC Feed ground connection.
4
Connect the two Black pair wires to the DC Feed -48VDC connection.
Bale fits over
and onto the
power cord.
Summary of Contents for OmniStor 4700S Series
