Qvis IAPOLLO HDRT HD, User Manual

Page: 47 / 227

© Copyright Qvis® All documentation rights reserved.
38
3.7.1.3 iApollo PRODC
The general 2U series product interface is shown as in Figure 3-4.
Figure 3-4
You can refer to the following sheet for alarm input and output information.
1
，
2
，
3
，
4
，
5
，
6
，
7
，
8
，
9
，
10
，
11
，
12
，
13
，
14
，
15
，
16
ALARM 1 to ALARM 16. The alarm becomes active in low voltage.
NO1 C1
，
NO2 C2
，
NO3 C3
，
NO4 C4,
NO5 C5 NC5
The first four are four groups of normal open activation output
(on/off button)
NO5 C5 NC5 is a group of NO/NC activation output (on/off button)
CTRL 12V Control power output. The power output is off when the alarm is
canceled.
+12V It is rated power output.
Earth cable.
485 A/B 485 communication port. They are used to control devices such as
PTZ. Please parallel connect 120T
Ω between A/B cables if there are
too many PTZ decoders.
3.7.2 Alarm Input Port
Please refer to the following sheet for more information:

Normal open or Normal close type.

Please parallel connect COM end and GND end of the alarm detector (Provide external
power to the alarm detector).

Please parallel connect the Ground of the DVR and the ground of the alarm detector.

Please connect the NC port of the alarm sensor to the DVR alarm input(ALARM)

Use the same ground with that of DVR if you use external power to the alarm device.
AB cable
connection