© Copyright Qvis® All documentation rights reserved.
32
3.3.3 iApollo PRODC
This series DVR max supports 8 SATA HDDs. Please use HDD of 7200rpm or higher.
Important:
If the HDD amount is less than four, you do not need to install the HDD bracket. When there is a
bracket, please make sure the installation direction of HDDs is the same.
1. Loosen the screws of the
upper cover.
2. Remove the HDD upper
bracket
3
.
Now you can see the bottom
bracket
4. Line up the HDD to the
four holes of the HDD
bracket.
5. Use screws to fix HDD.
6. Install the upper bracket and then
Use screws to fix HDD in the
bracket.
7. Unfasten the HDD power
cable.
9.
Use the special data cable to
connect the HDD and the SATA
port. Close the chassis and fix
the screws to secure firmly.
8. Insert the HDD power
cable.
1. Loosen the screws of the
upper cover.
4. Line up the HDD to the
four
holes
of
the
HDD
bracket.
Summary of Contents for IAPOLLO HDRT HD
