Quantronix CUBISCAN 325, Service Manual

Page: 62 / 98

COMMUNICATIONS PROTOCOL Cubiscan 325 command set
CubiScan 325 Service Manual 52
Command set summary
The Cubiscan 325 recognizes the following commands from the command set for a serial, USB,
or Ethernet connection.
The table below shows the Command Set Summary.
(A) - Command Character
(B) - Command Hex Value(s)
User Command Name (A) (B) Page
“Build number” b 62h 53
“Cubiscan 100 compatible measure
mode” M 4Dh 53
“Dimension units” “ 22h 55
“Emitter toggle” e 65h 56
“Factor table” f 66h 57
“Factor toggle” F 46h 58
“Flash firmware” l 6Ch 59
“Gate measure” m 6Dh 59
“Identification/Serial number” I 49h 61
“Key coordinates” k 6Bh 62
“” L 4Ch 62
“Model” ! 21h 63
“Reset system” x 78h 64
“Save parameters” . 2eh 65
“Scale calibration” S 53h 66
“Scale reading” s 73h 67
“Scrape screen” a 61h 68
“Serial get” g 67h 68
“Serial loop back” P 50h 69
“Serial put” p 70h 70
“Smallest box mode” j 6Ah 71
“Test” T 54h 72
“Units” U 55h 73
“Values” V 56h 74
“Weight units” # 23h 76
“Zero” Z 5Ah 76