DIAGNOSTICS
Booting process errors
Cubiscan 325 Service Manual
2
Booting process errors
This section describes the various booting process errors that can occur with the Cubiscan 325.
Refer to the following sections for more information.
Failure in initialization process
Review the following information if there is a failure in the initialization process when the
Cubiscan 325 is turned on.
Initialization file
This process may fail if the SD card is missing or fails to load a needed file. Complete the
following steps if the initialization file process fails.
Note
Upon initialization failure, the Cubiscan 325 will use default settings. This may impact calibration.
1. Tap
Menu
> Units
on the Cubiscan 325 touchscreen. Temporarily change any of the settings
on this screen to force the SD card to write.
2. Reboot the Cubiscan 325. Continue on to the next step if rebooting the system doesn’t work.
3. Verify that an SD card is installed. The SD card is located in the controller box. Remove the
SD card and make sure that the param.txt file is installed. For instructions on removing the SD
card, see
“Updating the Firmware” on page 19
.
4. Try using a new SD card (2-4 GB, standard or HC) with factory default parameter files.
5. If, after completing the above steps, the initialization file process still fails, please contact
Cubiscan Technical Assistance at 801.451.7000.
Reading gate
This process may be delayed and read
DONE
instead of
PASS
if the Cubiscan 325 fails to detect
gate board(s). Complete the following steps if the reading gate process reads
DONE
.
1. Make sure that the gate power cable is securely connected.
2. Make sure the gate ribbon cable(s) are connected.
3. Reboot the Cubiscan 325.
If, after completing the above steps, the reading gate process still fails, please contact Cubiscan
Technical Assistance at 801.451.7000.
Strobing gate
If this process fails contact Cubiscan Technical Assistance at 801.451.7000.
