Quantronix CUBISCAN 325, Service Manual

Page: 50 / 98

PART REPLACEMENT Replacing the power supply
Cubiscan 325 Service Manual 4 0
5. Disconnect the following cables that connect to the
outside of the controller box. See Figure 48 .
–Load Cell Summing Cable
–Depending on your connection choice, you may only
need to remove one (or none) of the following cables:
Ethernet, USB, or serial.
6. Disconnect the three ribbon cables that are attached
to the motherboard. See Figure 49 .
7. Disconnect the proximity sensor cable (part number
13320), the encoder cable (part number 13319), and
the gate power cable (part number 13314) where
they connect to the motherboard. See
Figure 49 .
8. Using the Phillips screwdriver, remove the screws
(four total) located on each corner of the
motherboard.
9. Carefully remove the motherboard and set it aside.
10. Disconnect all three of the cables attached to the
power supply. You may need to use pliers to remove
the ground cable connection. See
Figure 50 .
11. Using the Phillips screwdriver, remove the screw
holding the power supply cage lid in place. See
Figure 51 .
12. Remove the cage lid and set it aside.
13. Using the Phillips screwdriver, remove the four
screws holding the power supply board down. The
screws are located in each corner of the power
supply board.
14. Remove the power supply and discard it.
15. Locate the replacement power supply and screw it
into place.
16. Reconnect the power supply cables.
17. Replace the cage lid and screw it into place.
18. Replace the motherboard and screw it into place.
19. Reconnect the motherboard cables.
Figure 48
Controller box connectors
Figure 49
Motherboard cables
Figure 50
Power supply cables
Gate DB25
ribbon
Gate
power
Gate DB9
ribbon
encoder
Proximity
sensor
Serial
USB
Ethernet
Display
Load Cell
summing
Ground
cable
Gate power
Ribbon cables
Encoder
Proximity
Power supply cables