PART REPLACEMENT
Replacing a height receiver board
Cubiscan 325 Service Manual
2 7
5. Shut the fuse drawer.
6. Reconnect the power cord.
7. Power the Cubiscan 325 on.
Replacing a height
receiver board
This section describes how to replace the height
receiver board on the Cubiscan 325.
Items needed
–Regular and small Phillips screwdriver
–Replacement height receiver board
Complete the following steps to replace a height
receiver board. The height receiver boards are the
boards located on the front side of the gate.
1. Power the Cubiscan 325 off.
2. Remove the six screws shown in
and then
remove the gate cover.
3. There are two height receiver boards that can be
replaced, the top and bottom board. Make sure you
replace the correct board.
4. Disconnect the ribbon cables by simultaneously
pushing the tabs located on each end of the
connector outwards. The ribbon connectors are
shown in
5. Disconnect the power cables, indicated in
6. Using the small Phillips screwdriver, unscrew the six
screws holding the transmitter board in place.
7. Carefully remove the damaged board and replace it
with the new board. Handle the board with care; the
LED’s are fragile and can be broken. Make sure you
orient the board correctly, with the power connector
in the bottom-left corner.
8. Screw the replacement board into place.
Figure 16
Height receiver gate cover
Figure 17
Height receiver inside top view
Figure 18
Height receiver inside bottom view
