Printronix P6000L, User'S Reference Manual

Page: 22 / 234

Operation 2-2
Bit Image graphics or P-Series compatible Plot Mode, is programmed on a line-by-line baĆ
sis.
This chapter will discuss the following procedures:
n
Power Switch
n
Lock/Unlock Function Switches
n
Control Panel
n
Paper Adjustment Controls
n
Loading Paper
n
Unloading Paper
n
Setting Top-of-Form
n
Paper Stacking - Floor Cabinet Models
n
Selecting Print Mode
n
Setting Forms Length
n
Loading the Ribbon
n
Setting Line Spacing
n
Hex Code Printout
n
Printer Reset
n
Running the Self-Test
For information on the RibbonMinder feature, refer to the RibbonMinder chapter.
Power Switch
The printer must be connected to the proper power source, 120/240 V 50/60 Hz, as shown on
the rear panel label. Applying an incorrect power source will damage the printer. Complete
power requirement information is provided in the Installation chapter.
On floor cabinet models, the printer ac power switch is located on the lower left corner of the
rear panel as shown in Figure 2-1. On pedestal models, the printer ac power switch is located
on the lower left side panel as shown in Figure 2-2. To turn the printer power on, set the power
switch to the ON position.