Printronix P6000L, User'S Reference Manual

Page: 27 / 234

2-7 Operation
D
Diagnostics
After the required menu is displayed, individual parameters are displayed using the CONFIG
VALUE switch as shown on the Control Panel Switch Function Diagram in the Configuration
chapter.
CONFIGURATION VALUE - Press Configuration Value (CONFIG VALUE) to display indiĆ
vidual configuration parameters and the current value from within the main menus.
NOTE: Alternately and/or repeatedly pressing CONFIG MENU and CONFIG VALUE
allows the display of the configuration parameters as shown on the Control Panel Switch
Function Diagram in the Configuration chapter. The CONFIG MENU and CONFIG
VALUE switches when pressed simultaneously step backward through the configuration
menu, forms length, and print mode selections.
RUN/STOP TEST - The RUN/STOP TEST switch performs the following functions:
n
Press RUN/STOP TEST simultaneously with CONFIG MENU to alternately unĆ
lock and lock the printer configuration..
n
Press RUN/STOP TEST to select a configuration parameter, forms length, or print
mode. An asterisk (*) will appear to the right of the value to indicate that it has been
selected.
n
Press RUN/STOP TEST simultaneously with CLEAR FAULT to reset the printer.
n
If a self-test is selected and shown on the display, press RUN/STOP TEST to start
the test and press it again to stop the test.
n
If the CONFIGURATION PRINTOUT message is selected and shown on the disĆ
play, press RUN/STOP TEST to print a list of the current configuration. Press RUN/
STOP TEST again to return to OFFLINE READY.
CLEAR FAULT - Press this switch to reset the printer after a fault condition has been corĆ
rected. Fault conditions are indicated on the display. After pressing CLEAR FAULT the disĆ
play will indicate the printer is offline if the fault was corrected.
In addition, the CLEAR FAULT switch performs two special functions:
n
Press CLEAR FAULT simultaneously with RUN/STOP TEST to reset the printer.
n
Press CLEAR FAULT when one of the parameter values is displayed to move up one
menu parameter selection or to offline. Refer to the Control Panel Switch Function
Diagram in the Configuration chapter.
Paper Adjustment Controls
The printer paper loading controls for the floor cabinet model are shown in Figure 2-4. The
printer paper loading controls for the pedestal model are shown in Figure 2-5. The controls
are the Forms Thickness Adjustment Lever (A), the Vertical Position Knob (B), the Horizontal
Adjustment Knob (C), and the paper tractors (D). The PAPER ADVANCE switch on the conĆ
trol panel is also used during the paper loading procedure.