Printek FP5000 series, User Manual

Page: 117 / 201

Advanced menu User guide
104
Paper handling (Paphand)
The Paphand group of menus improves the possibilities for the trou-
blefree printing of paper with properties likely to cause problems
(perforations etc.) or paper of poor finish.
Put the printer into Test mode by pressing the key Online while
switching on the printer. The display shows ASCII80 ASCII136 .
Change to the parameter group Formlen AGA by pressing the key
Next three times.
Select the Paphand menu (2).
Select the Head up menu (2).
Increasing the printhead gap
(Head up) With this function you can increase the printhead gap before and af-
ter the perforation of the form.
Setting options: On/Off
Default setting: Off
If the parameter is set to On , the printhead gap increases during
form feed and line feed four lines before and after the perforation on
the form (= protected zone). The printhead gap is always increased
during form feeding past the perforation even when feeding takes
place outside the protected zone.
Printing is possible in the protected area.
Confirm the setting by pressing the Set (1) key.
Paphand CX-bid
Online
Setup
Back Next
2 1 3 4
Head up Pagewid
Online
Setup
Back Next
2 1 3 4
Head up=Off *
Online
Setup
Set < > Exit
2 1
3
4
1
2
2
3
4
5
6
8
7
1 Top edge of form 5 Protected zone
2 Paper transport strip 6 Transport holes
3 Bottom edge of form 7 Left Zone
4 Form separation perforation 8 Right Zone