PrimeLab 1.0 MULTITEST, User Manual

Page: 220 / 353

187 187
10 ml
24 mm
4
4
1.) Set up the fridge to 15°C by using the thermostate according to the
manual.
2.) Fill a cleaned cell (24mm) with 10ml of your sample.
3.) Close the lid.
4.) Place the vial inside the fridge for 20:00 minutes.
5.) Place the sealed "Methanol Zero" vial into the PrimeLab and press
ZERO.
6.) Remove the the cell from the PrimeLab and set it aside. It is not longer
required for this test.
7.) Remove the cell from the fridge.
8.) Add 1 PTT Phot. tablet to your sample.
9.) Crush the tablet with a clean stirring rod.
10.) Close the lid.
11.) Place the vial inside the fridge for 10:00 minutes.
12.) Press TEST to start 10:00 minutes countdown.
13.) Remove the cell from the fridge.
14.) Remove condensate on vial by using a dry soft cloth.
15.) Place the cell into the photometer (use caution to the arrow on the
cell) and press TEST.
Tablet
Name on device: 159-PTT-tab
The individual steps of the measurement procedure are shown on the display.
Use button 3 (arrow down) to scroll through the steps.
Use button 4 to skip the notes.
!
Measurement procedure:
The steps up to the selection of the parameter value to be determined are the same for all
procedures and described on page "TEST-5".
Please observe the important notes for
accurate measurements on pages "TEST-8" and "TEST-9".
(159)
Permanganate Time Test 0 - 100 %A
(Absorption)
PTT Photometer
(TbsPTT...)
Continued...
4