4. Reinstall the ramp onto the ramp pivot hinge.
a. Place the ramp cover mounting clip onto the ramp. Then set the ramp onto the
ramp pivot hinge aligning the two ramp cover mounting clip bolt holes. Secure
using the two #2 Phillips screws. Do not over tighten the screws, torque to 30 in-
lbs (3.4 Nm).
b. Finish securing the ramp to the ramp pivot hinge using the four 9/16" bolts (4x)
and washers (4x), torque bolts to 1080 in-lbs (90 ft-lbs or 122 Nm).
5. Preparing the Ramp wheel tracks:
a. Use a clean rag and approved cleaner (see
) to clean both wheel
tracks. Clean any hard-to-remove grime using a Scotch-Bright pad (or fine steel
wool). Dry ramp track surfaces with a clean rag.
b. Apply a thin coat of Swix UR10 Yellow Bio Racing ski wax (or equivalent) to the
wheel contact area of the ramp wheel tracks. Rub the wax back and forth across
the length of the track several times. Ski wax is preferred to oil based lubricants
because ski wax is less prone to attract dust and dirt.
c. Gently wipe away any excess wax with a clean rag.
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 176
6 Replacement Procedures
Ramp Replacement
