4. Remove the Moving Arm:
a. Loosen, but do not remove, the 3/16" hex key pivot shaft
outer
set screw.
b. Then remove the 3/16" hex key pivot shaft
inner
set screw and gently pull the
Moving Arm outward and over the side cover to remove. Retain part(s) and/or
fastener(s) for installation.
Installation Instructions
1. Reinstall the Moving Arm pivot shaft into the weldment moving arm pivot mount bar.
2. Then reinstall the 3/16" hex key pivot shaft
inner
set screw.
3. If the 3/16" hex key pivot shaft
outer
set screw was removed, reinstall the
outer
set
screw.
4. Tighten both the
inner
and
outer
set screws and torque to 300 in-lbs (34 Nm).
5. Reinstall the upper corner and middle front #3 Phillips side cover weldment screws,
torque to 30 +/- 9 in-lbs (3.4 +/- 1 Nm).
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 159
6 Replacement Procedures
Linkarm Replacement
