1. Access the service menu diagnostic
CrossRamp Test
and set the incline level to 1
(default level)
a. P10, P30, P30i and P31: (
Service menu (51765761)
>
MACHINE TEST
>
CROSSRAMP TEST
and raise the
INCLINE LEVEL
to 1).
b. P62, P80, and P82: (
Service menu (51765761)
>
System Settings
>
System
Tests
>
CrossRamp Test
and raise the
INCLINE
level to 1).
2. Disconnect either the battery negative terminal or the Lift Motor input power/control
cable.
WARNING
: Make sure to disconnect either the negative battery terminal or the Lift
Motor input power/control cable to prevent accidental ramp movement. This unex-
pected action could cause personal injury.
3. Remove the Stairarm wheel truck assemble from the ramp track and lay the Stairarm
on the floor. To remove, grasp the bottom of the wheel truck assembly and lift up and
outward to remove from the track. No tools or fastener removal is required. It may help
to lift the outer edge of the CrossRamp cover while removing.
4. Then position the Stairarm wheel truck at approximately the 10 o'clock position behind
the input drive housing by lifting the Stairarm wheel truck upward and rearward until it
rests behind the input drive housing. This positioning of the Stairarm will provide access
to the wheel truck assembly fasteners.
Contact Precor Customer Support at [email protected] or 800.786.8404 with
any questions.
Page 163
6 Replacement Procedures
Wheel Truck Replacement
