Operation and installation manual
Page 22 of 82
(PVI-10.0/12.5-OUTD-xx Rev:1.2)
3.4
Wall mounting
AURORA shall be mounted in a vertical position, as shown in figure 6.
In the package you will find a kit consisting of 5 steel screws 6.3x70 (with 5 M6
washers) and 5 blocks SX10 necessary to fasten the metal bracket onto a wall. Screws
and blocks can be fitted into the 3 holes provided onto the metal bracket (Part C) and
then into the two holes available on inverter bottom (Part B)
WARNING
: fasten bracket horizontally on wall, its side provided with
springs shall be facing up, while the side with mounting holes shall be facing
down.
The diameter of the holes to be drilled on the wall is 10 mm, and minimum depth is
75mm.
Installer shall use suitable mounting material, according to the wall material. It is
recommended to always use stainless steel screws.
Fasten AURORA to springs (Part D) located on bracket top part, by means of the
metal mount fastened to inverter back plate top part. This metal plate features some
drafts at the point where bracket springs fasten (Part A).
Once inverter top part is fixed, fasten the bottom part by fitting the screws in the
provided holes.
AURORA FRONT END
AURORA BACK
Part A
Part B
