Operation and installation manual
Page 49 of 82
(PVI-10.0/12.5-OUTD-xx Rev:1.2)
5.5.2
Error Messages
After the connection is established, the inverter runs a test cycle; if wrong values are
found, the cycle is interrupted and an error code is displayed. To acknowledge the
error, please refer to the chart under section 5.4.
To customise the message to be displayed follow the programming procedure
explained in section 5.5.6.15 “Alarm Message”.
Until the error is rectified, the display will cycle through the following screens:
Once the error has been removed, the inverter resets all functions in progress and
restarts the connection (section 5.5.2 System connection to the grid, item 2).
- Missing grid
- Waiting sun
5.5.3
First stage, checking the various electrical parameters
GENERAL ISSUES ABOUT THE USE OF DISPLAY KEYS:
During regular operation, the display will cycle through available data. Screen pages
change every 5 seconds, or you can manually scroll through them by pressing UP (2
nd
key on display) and DOWN (3
rd
key on display).
In all cases, to go back to previous menu just press ESC (1
st
key on display).
Fig.22
Fig.23
Auto-scroll is indicated by 2 arrows in the top left corner of the display (Fig. 22).
Scrolling can be locked by pressing
ENTER
(4
th
key on display) and the lock symbol
is displayed (Fig.23).
Custom msg………
Type OUTD
Part No………
S/N ………..……..
Firmware…………
In range
ERROR
Code ……..
