![background image](http://html1.mh-extra.com/html/patton-electronics/smartnode-series/smartnode-series_software-configuration-manual_4048643597.webp)
Introduction
597
SmartWare Software Configuration Guide
49 • SIP profile configuration
Introduction
The SIP profile specifies disconnect cause mappings from SIP codes to Q.931 causes, and vice versa. As for all
profiles, there is a
default
profile at system startup that can be modified. Only those causes that differ from the
default mapping have to be configured. If a new profile is created, all mappings are set to their default and are
only overwritten if configured. The default mapping in both directions is according to RFC3398 - ISUP to SIP
Mapping.
A SIP profile can either be attached to SIP interfaces or to identities. To see how to configure a SIP profile for
an interface, see Chapter 39,
“SIP interface configuration”
on page 436. For information about SIP profile
configuration for identities, see Chapter 51,
“Location Service”
on page 602.
SIP profile configuration task list
This section describes the configuration tasks for SIP profile listed below.
•
Enter the configuration mode for a SIP profile (see
page 597
)
•
Map
from
a SIP disconnect cause
to
a Q.931 cause (see
page 597
)
•
Map
to
a SIP cause
from
a Q.931 disconnect cause (see
page 598
)
•
Map
from
a SIP redirection code
to
a Q.931 redirect reason (see
page 598
)
•
Map
to
a SIP redirection code
from
a Q.931 redirect reason (see
page 598
)
Entering the configuration mode for a SIP profile
The
profile sip
command enters the configuration mode of an existing profile or creates a new one with a spec-
ified name. It also destroys an existing profile except the default, which always exists.
Mode:
Configure
Mapping from a SIP disconnect cause
The
map cause from-sip
command maps a specific SIP disconnect cause to a Q.931 cause used by the call con-
trol. All causes are pre-defined in the system and are provided by the command.
Mode:
Profile SIP
Step
Command
Purpose
1
[name](cfg)#[no] profile name
<name>
Creates/Destroys a SIP profile or enter the con-
figuration mode of an existing one.
Step
Command
Purpose
1
[name](pf-sip)[name]#map cause from-
sip
sip-cause
to
q931-cause
Maps a specific SIP disconnect cause to a
Q.931 cause.