Basic IP routing configuration task list
236
SmartWare Software Configuration Guide
22 • Basic IP routing configuration
Deleting static IP routes
The
no
form of the
route
command deletes a static IP route from the routing table.
This procedure describes how to delete one or more static IP routes from the routing table
Mode:
Administrator execution
Example:
Deleting a static IP route
In the following example, the route for packets to network 20.0.0.0/24, which are routed to device with IP
address 172.17.100.2, shall be deleted.
node>enable
node#configure
node(cfg)#context ip router
node(ctx-ip)[router]#no route 20.0.0.0 255.255.255.0 172.17.100.2
Displaying IP route information
This procedure describes how to display static IP routes
Mode:
Operator or administrator execution
This command displays the destination address, next-hop interface, protocol (local, static, RIP, or ICMP),
metric, flags (
U
–up,
H
–host,
G
–Gateway,
L
–local,
D
–default), and amount of use for each route in the routing
table. If there are multiple routes to the same destination, the preferred route is indicated by an asterisk (*).
Example:
Displaying IP route
In the following example, IP route information is displayed.
node>show ip route
Routes of IP context 'router':
Status codes: * valid, U up, H host, G Gateway, L local, D default
Destination Nexthop Protocol Metric Flags Used
---------------------------------------------------------------------
* 127.0.0.1/32 local 0 LHG n/a
* 172.16.40.77/32 local 0 LHG n/a
* 172.17.100.210/32 local 0 LHG n/a
* 172.17.100.0/24 wan local 1 UL 0
* 20.0.0.0/24 172.17.100.2 static 0 U 0
* 172.16.0.0/16 lan local 1 UL 6
Step
Command
Purpose
1
node
(cfg)#context ip router
Enters the IP router context
2
node
(ctx-ip)[router]#no route
network mask
{
address
|
interface
}
Deletes a static route
Step
Command
Purpose
1
node
>show ip route
Displays IP route information
