![background image](http://html1.mh-extra.com/html/patton-electronics/smartnode-series/smartnode-series_software-configuration-manual_4048643556.webp)
Context SIP Gateway configuration task list
556
SmartWare Software Configuration Guide
46 • Context SIP gateway overview
1.
From-URI-Host
equal
Remote
and
Request-URI-Host
equal
Local
2.
From-URI-Host
equal
Remote
3.
Request-URI-Host
equal
Local
4.
No match, the first configured will be taken
For detailed information about call control SIP interface configuration, see Chapter 39,
“SIP interface config-
uration”
on page 436.
Context SIP Gateway configuration task list
The following section describes how to create a new context SIP gateway and how to enter the configuration
mode of an existing context SIP gateway. Additionally, it describes all commands and sub commands of the
context SIP gateway configuration mode. All configuration tasks for a Context SIP Gateway are listed below.
•
Create a context SIP gateway (see
page 556
)
•
Create a transport interface (see
page 557
)
•
Configure the IP binding (see
page 557
)
•
Configure a priority (see
page 557
)
•
Configure a spoofed contact address (see
page 558
)
•
Bind location services (see
page 558
)
•
Enable/Disable (see
page 558
)
Creating a context SIP gateway
The
context sip-gateway
command enters the configuration mode of a context SIP gateway. If the requested
one does not exist, a new one will be created. The no form of the command removes an existing context SIP
gateway. This command can be entered without specifying a name. In this case, the default name
sip
will be
taken.
Mode:
Configure
Step
Command
Purpose
1
[
node
](cfg)# [no] context sip-gateway
[
<name>
]
Creates/Destroys a context SIP gateway or
enter configuration mode.