PPP configuration task list
280
IPLink Software Configuration Guide
25 • PPP configuration
IPLink(pf-ppp)[PPPoE]#mru min 68 max 1492
IPLink(pf-ppp)[PPPoE]#van-jacobson compression
IPLink(pf-ppp)[PPPoE]#port ethernet 0 0
IPLink(prt-eth)[0/0]#pppoe
IPLink(pppoe)[0/0]#session green
IPLink(session)[green]#use profile ppp PPPoE
Displaying PPP configuration information
This section shows how to display and verify the PPP configuration information.
Mode: Configure
Example:
Display PPP subscriber configuration information
IPLink(session)[green]#show subscriber ppp joe_example
Subscribers:
------------
Name: joe_example
Direction: dial-out
Authentication: pap
Identification (inbound): (none)
Identification (outbound): patton/patton
Timeout for disconnect: no absolute timeout, no idle timeout
Max. sessions: no limit
IP address: (none)
Callback: (none)
Binding: interface ppp_interface router
Binding: interface ppp_interface router
Step
Command
Purpose
1
node(cfg) #show running-config
Gives the best overview of all PPP related configura-
tion information. The following parts are of interest:
•
profile ppp default
•
profile ppp
name
•
interface
name
•
subscriber ppp
name
•
port ethernet
slot port
•
session
name
2
node(cfg) #show subscriber ppp [
name
]
Displays configuration information of the PPP sub-
scriber
name
or of all PPP subscribers
3
node(pf-ppp)[name]#show profile ppp
{
name
| default }
Displays the PPP profile
name
or the default PPP
profile